![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
![]()
I have a question for all the electronic wizards out there. My radio is only giving a carrier signal but no modulation. I have the following set-up:
Dittel FSG71M Dittel speaker box F10061 with two DIN connectors for two microphones (only one used) Dynamic goose neck microphone F10039 I tried both goose neck mic.'s I have in both positions on the box. The yellow LED on the radio turns on but no voice transmission occurs. The power supply is provided by two 12V, 9.6Ah Lithium Iron Phosphate batteries in parallel which are rock-solid. Any suggestion for where to start trouble-shooting? Thanks, Uli |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Radio acting up | Blake Seese 3Y | Soaring | 28 | February 1st 16 02:27 PM |
Acting FAA Administrator | FredGarvinMaleProstitute | Piloting | 3 | September 28th 07 02:36 PM |
GoogleGroups Acting Hinky? | Jay Honeck | Piloting | 37 | May 5th 07 07:54 PM |
Garmin 196 acting up | Glenn Westfall | Piloting | 8 | March 17th 04 12:32 PM |
Garmin 196 acting up | Peter Duniho | Piloting | 3 | March 16th 04 01:16 PM |