|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
November 2nd 03, 09:36 AM
|
|||
|
|||
Cutting plasma rope
There is considerable interest in the UK in using
plasma/dyneema rope for winch launching. However, the main obstacle appears to be finding an efficient method of cutting the rope in event of an emergency. Has anyone ot there found the definitive method??? 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Plasma Ropes ----- Help | Dave Martin | Soaring | 7 | October 1st 03 12:23 AM |
| Tow Rope Freindly Fences | John Spargo | Soaring | 8 | September 2nd 03 05:17 AM |
| Using Plasma Rope For Winch Tows | Craig Freeman | Soaring | 56 | August 24th 03 11:55 PM |
| Winching: Steel vs. Plasma | Bob Johnson | Soaring | 10 | August 12th 03 06:41 PM |
| 2nd update on Review of Plasma II Ignition System | MikeremlaP | Home Built | 8 | July 22nd 03 02:37 AM |
Threaded Mode