|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
February 22nd 05, 11:45 PM
|
|||
|
|||
Safety and Hot Wire Foam Cutting
A friend of mine just bought a hot wire foam cutting tool for carving
and shaping polystyrene foam. My question is whether the fumes and smoke from doing such carving are a safety/health hazard? Any guidelines for using such a tool safely? Thanks. -Fleemo 
|
| Thread Tools | |
| Display Modes | |
|
|
Threaded Mode