|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
March 7th 05, 09:08 AM
|
|||
|
|||
Sharing static and pitot line
Dear All,
I have seen several posts about how to share the TE line between e-vario and mechanical one. Maybe I am wrong but I can not see any post about sharing the pitot pressure (dynamic) between ASI, e-vario (computer) and and the only one static port between e-vario, altimeter and mechanical vario. Any good advice or this is not a problem at all ? 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Why are TE probes so long? | Duane Eisenbeiss | Soaring | 36 | May 9th 04 07:58 AM |
| Fine example of Tarver Engineering release for service | running with scissors | Military Aviation | 79 | March 3rd 04 02:48 PM |
| Fine example of Tarver Engineering release for service | running with scissors | Instrument Flight Rules | 64 | March 3rd 04 06:01 AM |
| Chuck Yeager-pitot tube | Ron | Military Aviation | 44 | October 9th 03 04:13 AM |
| Pitot and static couplings for a TTU-205 | B2431 | Home Built | 0 | August 15th 03 08:25 AM |
Threaded Mode