|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
May 1st 05, 01:58 PM
|
|||
|
|||
Composite Prime & Paint solutions
Looking for some comments on the best choices for PRIMING & PAINTING
composite aircraft. UV protection - Easy to work with etc..... Poly-Fiber makes a roll-on UV Smooth prime for instance, so some of the finish work can be done in the garage. Thoughts folks? Thanks. 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Good Paint Remover? | Marco Leon | Owning | 2 | June 22nd 04 08:58 PM |
| cleaning engine | Robert M. Gary | Piloting | 29 | December 6th 03 04:55 PM |
| Radar Absorbing Paint | robert arndt | Military Aviation | 2 | December 2nd 03 06:09 PM |
| Choice of Paint for use over Copper foil Antennas | Charlie Precourt | Home Built | 1 | December 2nd 03 03:51 AM |
| Defining Composites (long) | B Lacovara | Soaring | 1 | September 13th 03 09:04 PM |
Threaded Mode