|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
September 29th 11, 04:20 PM
posted to rec.aviation.soaring
|
|||
|
|||
Shaping wing tip skids
I have a pair of wing tip skids from Wings and Wheels. They are the
white ones, described on the website as "Gray/white soft rubber-like material skids". I need to shape them to fit the curvature of the wing. I have considered using the cylindrical end of my belt sander but am concerned with loading up the belt very quickly and rendering it useless. Six inch wide belts are not cheap. Has anyone tried to shape these to fit the wing? 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Slips and skids | William Hung[_2_] | Piloting | 25 | March 17th 08 02:27 AM |
| Re-shaping fiberglass parts with heat | JJ Sinclair | Soaring | 7 | November 5th 07 05:13 PM |
| Looking for Wing Tip Skids | [email protected] | Soaring | 2 | June 23rd 07 02:48 PM |
| High skids vs low skids | JKimmel | Rotorcraft | 0 | February 8th 06 01:15 AM |
| 2004 California airshow season shaping up! | Wings Of Fury | Military Aviation | 0 | December 31st 03 05:34 AM |
Threaded Mode