|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
August 16th 05, 08:55 PM
|
|||
|
|||
Bends, kinks and splices
How does an A&P know if he can simply straighten out a longeron or if
he's going to have to cut and splice? Obviously if it has a kink in it, it's very weak and would have to be spliced. Is there a reference? In the meanwhile I'll go read AC43.13 and see what they say. .. .. .. .. .. Well, 43.13 doesn't say when to bend or when to cut, so, the question stands. - Mike 
|
| Thread Tools | |
| Display Modes | |
|
|
Threaded Mode