|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
November 14th 05, 01:15 AM
|
|||
|
|||
Transponder problem...
Had a strange one today..
While squawking IDENT , our "ident" stuck "on" ATC confirmed we were continuously "identing" Cycling the transponder to off then on again cleared the ident fault. Pressing the button again locks the ident light on again until the power is cycled.. Any thoughts? Switch appears mechanically OK, (clicks when pressed, clicks when released).. It is a King KT78 "KT76TSO" Dave 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Transmittion Noise - High Power Settings | Paul Smedshammer | Owning | 6 | August 20th 05 06:17 PM |
| Operation without a transponder | flyer | Piloting | 11 | September 14th 04 08:48 AM |
| A Cheap and Dirty Transponder Tool | John P | Owning | 3 | June 15th 04 05:30 AM |
| Another Cirrus BRS deployment: | Dan Luke | Piloting | 111 | April 19th 04 04:34 AM |
| RF interference issue again (esp. for E Drucker and Jim Weir and other RF wizards) | Snowbird | Home Built | 78 | December 3rd 03 09:10 PM |
Threaded Mode