![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
![]()
I managed to lose one of the two approximately 18" metal water-valve
control rods for my LS-4 (don't ask - its a long and embarrasing story). This is the rod that extends from the pilot control on the right side of the cockpit back to the bulkhead. I contacted the factory (now DG) about obtaining a replacement and was told they are no longer in stock, and re-manufacturing them will probably be prohibitively expensive. Anyone know a source (new, used, whatever) for this part? I guess I could try stealing from another LS4 at a contest, but that could have 'negative consequences' ;-). TIA, Frank(X3) |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Cirrus chute deployment -- an incredible story | Michael182/G | Instrument Flight Rules | 48 | July 14th 05 03:52 PM |
Replacing fuel cut-off valve with non-a/c part??? | Michael Horowitz | Owning | 46 | January 15th 05 10:20 PM |
Water dump valve rotary seal | Bill Daniels | Soaring | 6 | May 10th 04 11:02 AM |
WTB: ASW 27A water valve | Peter Van Camp | Soaring | 0 | April 28th 04 10:37 PM |
Refinishing: Who has tried a shortcut? | Ian Forbes | Soaring | 60 | December 26th 03 09:30 AM |