|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
April 14th 07, 04:39 AM
posted to rec.aviation.homebuilt
|
|||
|
|||
Press-To-Test Lamp
My Press-To-Test indicator light for my landing gear has three lugs on the
back for three separate wires. Can anyone explain the appropriate hookup for these three lugs so that I'm sure to hookup the correct wire to each of the lugs? Thanks! 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Cost of Sandel 3308 projection lamp? | Dico | Owning | 1 | May 9th 06 12:22 AM |
| A different lamp base | Blanche Cohen | General Aviation | 15 | December 9th 05 05:32 PM |
| A different lamp base | Blanche Cohen | Piloting | 15 | December 9th 05 05:32 PM |
| A different lamp base | Blanche Cohen | Owning | 15 | December 9th 05 05:32 PM |
| Robot Plane Drops Bomb in Successful Test The Associated Press | Otis Willie | Military Aviation | 0 | April 19th 04 10:50 PM |
Threaded Mode