|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
July 8th 07, 06:49 AM
posted to rec.aviation.homebuilt
|
|||
|
|||
Probe problem
I changed a bad probe on one cyl. My Hanger mate and I had about 8
spares.with very little time. I tried 6 of these and the same thing happened. . When I snugged it up to the exaust pipe it would read 76..If I took it out and put heat to it it worked ok. I did this to 5 or 6 and the same thing happened. As soon as I snug it up it would not work. I can't figure out what is happening. I know all the probes can't be bad . any ideas Steve 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| TE Probe on ASW-15 | [email protected] | Soaring | 4 | April 29th 07 01:43 AM |
| Outside air temperature probe | dlevy | Owning | 9 | November 7th 06 05:14 PM |
| More on CHT probe replacement | Jim Burns | Owning | 12 | September 1st 05 10:45 PM |
| TE-Probe for 1-26D | Heinz Gehlhaar | Soaring | 6 | January 17th 05 10:52 PM |
| TE probe for SGS2-33 | Rod Pool | Soaring | 1 | May 20th 04 06:08 PM |
Threaded Mode