![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
![]()
I'm sure this has been discussed in the past, but I can't find a record of
the thread. I need to remove old painted ID from gelcoat and replace with new vinyl. What is the best method? Acetone? Wet sanding? Other options? Thanks much, Bill -- Posted via NewsDemon.com - Premium Uncensored Newsgroup Service -------http://www.NewsDem |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Removing RTV | John | Home Built | 6 | October 31st 06 10:07 PM |
Removing Ethanol from Gas? | Jay Honeck | Piloting | 67 | August 16th 06 03:29 PM |
Removing Decals | [email protected] | Home Built | 85 | September 9th 05 11:58 PM |
Removing old antennas | Jay Honeck | Owning | 30 | March 21st 04 04:34 PM |
Removing Old Contest Numbers | Milan Air | Soaring | 5 | November 25th 03 12:59 AM |