![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
![]()
In my early hours of being instructed, not one went by without stall
and spin practice. They also taught me to look out of the window. Maybe I've done a thousand or more turns before I found myself in a spin that I did not intend to happen. I was in an HP11, over a ridge, with a 1-26 out climbing me. "He can't do that!" With over 60 degrees bank, I just tightened my turn by pulling back on the stick. I increased my AoA without concern. Snap! The ridge was spinning below my nose and getting larger very fast. My old instincts kicked in. I was looking at the grass when I recovered. Now, AoA is my favorite subject to teach. My God! The ignorance is rampant. A tow pilot applied for a job. I asked him what the approximate angle of attack was for the Super Cub wing when it stalled. A commercial pilot raised his arm and pointed up about 40 degrees above the horizon. He went home. I was stunned. A favorite question I use for instruction... Which wing in a turn has the greatest angle of attack? The pilot has a 50-50 chance at the correct guess. No matter what his answer, I ask why? I get no answer. A problem I find is a lack of understanding of "relative wind" Is there no hope? I have witnessed a low altitude spin to impact. It was not nice. Another spin to impact gave me the opportunity to ask the pilot the question..."What makes the glider turn? His answer:"The rudder" He was a military acadamy pilot. We absolutly must teach and demonstrate more angle of attack recognition and recovery. It doesant take long before you hear or read about a stall spin fatality, Don't let your stundent go out into the wold without being trained in ALL aspects of AoA and stall spin recovery.Maybe the instructor should learn first. God bless good instructors,Fearless Fred |
Thread Tools | |
Display Modes | |
|
|