![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
|
#1
|
|||
|
|||
![]()
Is there a US supplier for the two-part adhesive system Aerolite? So
far it only seems to be available in the UK, exported only in large quantities. Any place to get a small quantity (eqiv of a pint) to experiment with? Corrie |
#2
|
|||
|
|||
![]() "Corrie" wrote in message om... Is there a US supplier for the two-part adhesive system Aerolite? So far it only seems to be available in the UK, exported only in large quantities. Any place to get a small quantity (eqiv of a pint) to experiment with? You say experiment with, this suggests that you don't know anything about it. Aerolite uses Formic Acid as it's hardner, you want to be very careful when using it as it can give you a very nasty burn, takes months to heal. -- .. -- Cheers, Jonathan Lowe modelflyer at antispam dot net Antispam trap in place Corrie |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Nomex flightsuit source | justin | Aerobatics | 7 | January 13th 05 04:23 AM |
Anyone recommend a source for designing hinged wings? | Tim Schoenfelder | Home Built | 8 | August 28th 03 02:07 AM |
Source for copper crush gaskets??? | Jim | Home Built | 2 | August 22nd 03 09:44 PM |