|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#3
February 27th 20, 03:03 PM
posted to rec.aviation.soaring
|
|||
|
|||
Cobra Trailer Fuselage Dolly Strap
On Thursday, February 27, 2020 at 9:49:14 AM UTC-5, wrote:
Anyone have advice for replacing the fuselage dolly strap for a cobra trailer? I got an estimate from Spindelberger and it's reasonable for the strap but the shipping is a bit much. Also, what's the best method to make the holes into the strap for attaching to the dolly? Thanks David David - you can buy the webbing from various sources. To make the hole, I use a hole-punch, which stamps out a nice sharp hole. I then use a lighter to 'cauterize' the open fibers. Put two holes into the end of the strap and double it over. Use two fender washers (one on each side of the strap) to spread out the load and give it a good pinch. Uli 'AS' 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Ka6 CR fuselage dolly | [email protected] | Soaring | 1 | February 14th 17 12:33 AM |
| Lining fuselage dolly | Colin Roney | Soaring | 0 | April 26th 14 10:19 AM |
| Cobra trailer wing dolly plastic sidewall rollers? | [email protected] | Soaring | 4 | May 9th 13 10:52 PM |
| Asw20 fusalage dolly wanted for cobra trailer | Gregg Leslie[_2_] | Soaring | 2 | January 14th 13 03:22 AM |
| ASK-21 fuselage dolly | bildan | Soaring | 8 | August 1st 10 05:43 PM |
Threaded Mode