![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#26
|
|||
|
|||
![]()
On Friday, June 5, 2020 at 1:50:59 PM UTC-4, WB wrote:
On Friday, June 5, 2020 at 12:26:21 PM UTC-5, wrote: Good and cheap are mutually exclusive. A good, safe machine won't be cheap. Right, but I thought the idea of the original question was to see if sacrificing some good (higher than 300 foot tow?) might make cheap and safe possible. Seems like a small corner case until there are lots more FES, but still fun to think about. A light duty winch to get you to 300 feet would still require all the same components as a heavy duty winch designed to get a Duo to 2000'. Assuming you will climb at a relatively shallow angle, you could get away with somewhat less power than a typical glider winch because you won't need to climb steeply as is done in a regular winch launch. Also, because line tension will be less in the shallow climb, your winch drum can be lighter. Brakes are critical on a winch to manage inertia of the drum/line and to put some tension on the in when reeling it out. A lighter system could have correspondingly lighter brakes. Your winch line will be under less tension, and with a low launch rate, wear would not be a big issue. You could forego expensive Dyneema line and just use polypropylene (might be a false economy eventually). These would all be small increments of "lighter, smaller, cheaper". Probably not enough to justify building it. My guess is it would be better to buy/build a regular winch or go with auto launch. Hard to get cheaper and simpler than an old car, a bucket of rope, and a tow release on a trailer hitch. You could forego expensive Dyneema line and just use polypropylene (might be a false economy eventually). I would advise against using polypropylene line since it has a much higher elongation compared to UHMWPE lines. It would most likely lead to a very unsteady launch with a lot of surging - like hanging on a bungee cord. Spectra or Dyneema have an elongation very close to what a steel cable has but at about 1/10 of the weight. That also plays into the overall equation for accelerating the line and then stopping everything with your drum brakes. Rather than building something on the 'Hold my beer - watch this' principle, spend the money and get the right stuff. Uli 'AS' |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
LX Mini Map | Andrew Blanchard | Soaring | 36 | March 8th 14 04:07 AM |
Mini-Imp | Curt Fennell | Home Built | 7 | November 10th 09 12:43 PM |
Best winch metrics - what is the best winch operationally? | Bruce | Soaring | 19 | July 19th 09 11:45 AM |
LIppmann reports a 950 meter winch launch with their Dynatec winch line - anything higher? | Bill Daniels | Soaring | 20 | December 27th 04 12:33 AM |
Mini Imp | Randall Robertson | Simulators | 3 | December 17th 03 05:56 AM |