Refinishing ASW24

On Sunday, September 20, 2020 at 4:18:06 PM UTC-4, Dan Marotta wrote:
How about posting some pictures, Bob. Of the '24, not you... :-D

Dan
On 9/20/2020 2:09 PM, wrote:
On Monday, September 7, 2020 at 5:40:31 PM UTC-4, wrote:
I have been working on the horizontal stab and the two elevators for the past two weeks. I have never seen such difficult gel coat to remove. I am no rookie at gel coat, have done many boats and a bit of glider repair, but this is a beast to remove. It took me six full days to remove the gel coat from the stab. Just today I did one elevator and will do the other tomorrow.
I am bringing it back up with acrylic urethane, so far so good, just a lot of work and a few drinks of rum. Bob
After countless hours of removing gel coat and filling , priming, sanding, sanding, sanding and then painting only to sand down, repaint and sand to 3000, I have finished! The scotch did not budge the gel coat, my fingers need rest, and my spray gun is finally clean again. I spent the last day buffing and doing a bit of sanding and buffing again. Now comes the fun part, putting it back together so my wife can have her ASW24 back.
--
Dan, 5J

Dan, let me see what I can do, Eileen is nagging me to death about not being able to fly her 24. Just today she told me that I should re surface the entire glider, I need more rum. Bob