|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#20
February 1st 21, 04:23 PM
posted to rec.aviation.soaring
|
|||
|
|||
USA automated panel-cutting service?
It can do panels for side-by-side gliders, too!
Thanks, Eric! I will keep that in mind. My current panel was laser-cut out of a thin sheet of Aluminum and has cut-outs for all the toys I need to fit. Uli 'AS' 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Some LiFePO4 Battery Testing Results Manual and Automated | John DeRosa OHM Ω http://aviation.derosaweb.net | Soaring | 32 | October 20th 19 03:26 PM |
| automated flap setting | Wallace Berry[_2_] | Soaring | 16 | September 26th 16 04:03 PM |
| Cutting 57mm holes in the instrument panel.....how to? | John Bojack[_2_] | Soaring | 20 | November 12th 10 09:15 PM |
| Automated Assisted Flight System | James Long | Home Built | 2 | March 5th 06 09:58 AM |
| FAI/IGC/CAI File Name Decoding - Automated!! | ContestID67 | Soaring | 9 | September 24th 05 09:26 AM |
Threaded Mode