![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
![]()
Anyone have experience with installing the oversize roller service kit for
Cessna's from McFarlane? Our tracks have a little ways to go before the .6035 wear limit but the wear is not even. We are getting some skin wear between the flaps and wing. Would these rollers be a viable alternative to new flap tracks, at least for a couple years? (Answers from those who have actually used or installed these please. I can guess as well as the next fellow.) -- Roger Long |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Flap Hinge Moment Calc | Bo | Home Built | 2 | February 2nd 05 10:26 AM |
Flap Hinge Moment Calc | Bo | Home Built | 0 | February 2nd 05 06:01 AM |
757 flaps miss-aligned in cruise | AnyBody43 | General Aviation | 1 | April 2nd 04 01:01 AM |