|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
January 20th 04, 01:41 AM
|
|||
|
|||
Fuel Compatability of PVC ? CPVC ?
I am building leading edge fiberglass tanks. I need
to insert a 3/8" I.D. tube about 8 ft long in which to insert the fuel level probe. I have concerns about the long term effects of fuel on the type of tubing I see in the plumbing/electrical dept in a the "Big Box" stores. Will this type of product stand up to aviation and auto fuel. If not I would like some idea or suggestions of a good product for this type of application 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Fuel dump switch in homebuilt | Jay | Home Built | 36 | December 5th 03 03:21 AM |
| Fuel Drip Containment | Sven | Home Built | 28 | October 27th 03 11:28 PM |
| Yo! Fuel Tank! | Veeduber | Home Built | 15 | October 25th 03 03:57 AM |
| Pumping fuel backwards through an electric fuel pump | Greg Reid | Home Built | 15 | October 7th 03 08:09 PM |
| Fuel pressure Problems | smf | Home Built | 3 | September 7th 03 09:25 PM |
Threaded Mode