|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#11
February 17th 04, 12:49 PM
|
|||
|
|||
"Orval Fairbairn" wrote in message
news 
...Tightening sequence: (1/2" first) This is something I was thinking of. What happens if one comes loose? Should you just tighten it to thee correct torque, or should the others be loosened then all tightened in sequence? Maybe even replacing the gasket? (don't know about gaskets...I would only guess as to the presence of one) Paul 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Could the Press Grow a Spine? | WalterM140 | Military Aviation | 259 | July 11th 04 08:35 PM |
| Fwd: [BD4] Source of HIGH CHTs on O-320 and O-360 FOUND! | Bruce A. Frank | Home Built | 1 | July 4th 04 07:28 PM |
| Compression loss on cylinder when rings line up Truth of fiction? | test it | Home Built | 10 | May 11th 04 08:11 PM |
| Maybe GWB isn't lying........ | JD | Naval Aviation | 9 | February 21st 04 12:41 PM |
| Air Force wife, kids found dead | Otis Willie | Military Aviation | 0 | July 19th 03 04:36 AM |
Threaded Mode