|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#17
May 18th 04, 12:39 AM
|
|||
|
|||
Jim Burns wrote: (I'm just assuming to circulate some oil through the engine and prop hub, but then again just how much would actually circulate when it's cold??) Pulling the prop through will do absolutely nothing to circulate oil. It usually takes several seconds for the oil pressure gauge to come off the peg after engine start, and that's at about 1,000 rpm. George Patterson I childproofed my house, but they *still* get in. 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Right prop, wrong prop? Wood prop, metal prop? | Gus Rasch | Aerobatics | 1 | February 14th 08 10:18 PM |
| Ivo Prop on O-320 | Dave S | Home Built | 14 | October 15th 04 03:04 AM |
| "I Want To FLY!"-(Youth) My store to raise funds for flying lessons | Curtl33 | General Aviation | 7 | January 9th 04 11:35 PM |
| PC flight simulators | Bjørnar Bolsøy | Military Aviation | 178 | December 14th 03 12:14 PM |
| IVO props... comments.. | Dave S | Home Built | 16 | December 6th 03 11:43 PM |
Threaded Mode