![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#11
|
|||
|
|||
![]()
Jim Weir wrote:
I usually expect to see 112-115 knots depending on temperature and loading. Jim Javier Henderson shared these priceless pearls of wisdom: -Jim Weir writes: - - Depends entirely on how hard you run the engine. I prefer 20" and 2300 RPM - (makes for a very smooth ride) and get just under 11 gph by the clock. - -What average TAS do you get at, say, 7500' with those settings? - --jav Jim Weir (A&P/IA, CFI, & other good alphabet soup) VP Eng RST Pres. Cyberchapter EAA Tech. Counselor http://www.rst-engr.com Jim, is that TAS or IAS? Seems low for TAS at that altitude. Matt |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
spaceship one | Pianome | Home Built | 169 | June 30th 04 05:47 AM |
Repairing Plastic Instrument Panel Overlay | Jeff P | Owning | 22 | January 29th 04 06:42 PM |
Yo! Fuel Tank! | Veeduber | Home Built | 15 | October 25th 03 02:57 AM |
Pumping fuel backwards through an electric fuel pump | Greg Reid | Home Built | 15 | October 7th 03 07:09 PM |
More long-range Spitfires and daylight Bomber Command raids, with added nationalistic abuse (was: #1 Jet of World War II) | The Revolution Will Not Be Televised | Military Aviation | 161 | September 25th 03 07:35 AM |