|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#6
September 17th 04, 08:23 PM
|
|||
|
|||
On Fri, 17 Sep 2004 16:02:45 GMT, "Roy Page"
wrote: I want to remove the KMA20, Dual HX170B's and KT76 from their trays so that I can easily clean up all the knobs faceplates etc. What special tools do I need to remove them ? And ... Where can I purchase ? Thanks in advance for the good response I know I will get. It only takes an allen wrench to remove them. 1/16" as I recall. (small hole in the bottom center or the front panel) Roger Halstead (K8RI & ARRL life member) (N833R, S# CD-2 Worlds oldest Debonair) www.rogerhalstead.com Roy Page 28291 Misty Morning Lane Beloit, OH 44609 330 537 8677 http://www.g4dyr.com 
|
| Thread Tools | |
| Display Modes | |
|
|
Threaded Mode