![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#23
|
|||
|
|||
![]()
In article ,
Chuck wrote: Come to think of it, I'd love to change the yokes in my Cherokee while I'm at it. Get some newer models instead of these original bow-tie yokes. And I guess same question would apply -- would they let me take from one certified model to another??? I don't know about the seats. But the old bowtie yokes can indeed be replaced by the new rams horn yokes. Look at the control wheel AD that applies to the bow-tie yokes. Notice that a terminating action is to replace them with the rams horn yokes. (I recently did that to my cherokee 140). -- Bob Noel |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Handheld battery question | RobsSanta | General Aviation | 8 | September 19th 04 03:07 PM |
VOR/DME Approach Question | Chip Jones | Instrument Flight Rules | 47 | August 29th 04 05:03 AM |
Phoenix AIM-54A (QUESTION) | Krztalizer | Naval Aviation | 10 | February 23rd 04 07:22 AM |
Tecumseh Engine Mounting Question | jlauer | Home Built | 7 | November 16th 03 01:51 AM |
Question about Question 4488 | [email protected] | Instrument Flight Rules | 3 | October 27th 03 01:26 AM |