|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#25
December 1st 04, 03:15 AM
|
|||
|
|||
In article ,
Chuck wrote: If you don't mind my asking Bob, what did you have to pay for those yokes??? I can't find my record of that - it was about two years ago. I'm pretty sure I got them from Wentworth. I think I paid $135 to powdercoat them. The parts required (bolts, joints, etc) were a chunk of money, and then the A&P needed about 19 hours of labor to replace the yokes. In other words, it wasn't cheap - but one of my yokes failed the AD for cracks. -- Bob Noel 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Handheld battery question | RobsSanta | General Aviation | 8 | September 19th 04 03:07 PM |
| VOR/DME Approach Question | Chip Jones | Instrument Flight Rules | 47 | August 29th 04 05:03 AM |
| Phoenix AIM-54A (QUESTION) | Krztalizer | Naval Aviation | 10 | February 23rd 04 07:22 AM |
| Tecumseh Engine Mounting Question | jlauer | Home Built | 7 | November 16th 03 01:51 AM |
| Question about Question 4488 | [email protected] | Instrument Flight Rules | 3 | October 27th 03 01:26 AM |
Threaded Mode