|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#7
February 6th 05, 01:31 PM
|
|||
|
|||
On Sun, 6 Feb 2005, Blueskies wrote:
Details about the oven? That would depend on the size of the windows. I made mine out of foil faced rigid insulation board, held into box shape with duct tape, the handyman's secret weapon. The tape went soft and let go when heated, so I had to use nails into wood corner strips. It was four by three by two feet overall. A baseboard heater three feet long was modified to eliminate the tip-over switch, so that it could lay flat on it's back on the floor of the oven. I had a thermometer stuck through the wall, and controlled the heater by unplugging it. The lid was hinged so that I could peek inside to watch the window. Certainly disposable. George Graham RX-7 Powered Graham-EZ, N4449E Homepage http://bfn.org/~ca266 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| molding plexiglas websites? | [email protected] | Home Built | 13 | February 6th 05 09:26 PM |
| Would you like to write about your hobby for one of the UK's top websites? | Steve Roche | Home Built | 0 | February 13th 04 10:36 AM |
| Zenith Ch 701 Builder's info and websites?? | DL152279546231 | Home Built | 1 | February 10th 04 08:21 PM |
| homebuilder websites updated daily? | Joa | Home Built | 6 | December 28th 03 07:30 PM |
Threaded Mode