|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#11
February 27th 04, 09:25 PM
|
|||
|
|||
Most roofing suppliers or contractors have sheet metal breaks. Most
of these place will do your bends for you(10' long, upto .063")for about a buck a piece plus $0.15 cents for additional bends on the same pieces. If you tell them you only need 10 to fifteen pieces and its for a homebuilt airplane, they might even bend them for free. Bryan 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Sheet metal shear/press brake | VideoFlyer | Home Built | 7 | October 7th 03 07:08 PM |
| ?s about building a gyrocopter | John Normile | Home Built | 2 | September 14th 03 02:01 AM |
| Brake caliper flange | Stealth Pilot | Home Built | 5 | July 7th 03 04:19 PM |
| Brake line design question | Charlie Smith | Home Built | 0 | July 2nd 03 12:31 PM |
Threaded Mode