|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
February 28th 04, 01:51 PM
|
|||
|
|||
Carbon Fiber Layup - Conformal Peel Ply?
I am doing wet layup in a covoluted mold using "porous teflon coated glass
peel-ply" between the lamnate and the breather. The peel-ply material is not at all conformal and the pleats/overlaps are interfering with resin takeup. Is there any other POROUS peel-ply material that is more conformal, better drape? Is there some kind of porous coating that could be sprayed on the laminate to perform the same function that could later be removed with solvent? 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Carbon fiber vs. antennas | Jim Weir | Home Built | 8 | January 2nd 04 01:40 PM |
| Foil antenna and carbon fiber | BD5ER | Home Built | 11 | August 6th 03 04:44 AM |
Threaded Mode