|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#12
November 9th 03, 02:53 AM
|
|||
|
|||
This unit was at one time installed in my plane before I owned it.
When they installed a "new" panel, they elected not to re-install it. They took out the receiver, head, loop & sense antennas. They left the tray, wiring from the tray, sense snub fir the sense antenna at the top, loop antenna connector & wire at the bottom. The three devices taken out were sent to an avionics shop to be checked out. I was under the assumption (stupid me), that all I had to do was slide the receiver in the tray, reattach the loop antenna, replace the sense antenna, and plug in the head.... Perhaps the damn thing read 180 out of phase the whole time???? dp 
|
| Thread Tools | |
| Display Modes | |
|
|
Threaded Mode