![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#6
|
|||
|
|||
![]()
Thanks!
Good, nice to be able to 'dial in' without any concern about certs... - Dan D. .. "rip" wrote in message news ![]() No, you'll know it when it happens. Rip Blueskies wrote: I backed the screw all the way out and didn't notice a lock plate fall off. Once I figured this out, it adjusted easily. All went back together just fine. Should I worry about a loose lock plate now? |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Recommendation for Radio, transponder and Altimeter | Ron Natalie | Home Built | 0 | July 8th 03 03:40 PM |