|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#4
April 15th 04, 03:24 AM
|
|||
|
|||
"nauga" wrote in message link.net... Van's used to sell straight restrictor fittings, an AN416-4 nipple to 1/8 pipe fitting filled and drilled with a teeny little opening. They don't seem to carry the straight ones anymore, and that's what I need. Neither does Wicks. Anyone know where to find 'em? Before someone says, "Make yer own!", my garage floor is littered with AN fittings filled with bolts, rivets, and solder, each one with a little broken drill bit sticking out of the middle. I didn't have much luck last time, so I'd prefer to buy outright this time. Dave 'fitting end' Hyde Have you considered tubing with the ID you want, and just soldering it in place? You can get your precision diameter without ever getting near a drill. Tim Ward 
|
| Thread Tools | |
| Display Modes | |
|
|
Threaded Mode