A aviation & planes forum. AviationBanter

If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

Go Back   Home » AviationBanter forum » rec.aviation newsgroups » Home Built
Site Map Home Register Authors List Search Today's Posts Mark Forums Read Web Partners

Replace fabric with glass



 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
  #34  
Old April 16th 04, 04:21 AM
Ernest Christley
external usenet poster
 
Posts: n/a
Default

wrote:

Ernest, it isn't the dope that provides the strength, not with
Razorback fabric or with any fabric. The fabric itself is what gives
the wing it's strength and/or stiffness against the wind. The initial
application of the correct dope, in the case of the Razorback fabric,
or a calibrated heating iron, in the case of the Polyfiber fabric, is
what shrinks it.

The application of paints on top of the fabric serve to protect it
from UV rays, make it waterproof, and look nice, but do not add
strength.

You should participate in one of Ron Alexander's fabric covering
sessions and see for yourself how it's done. They offer hands on
experience and you learn how to properly apply fabric to wings and
control surfaces. You will discover that the fabric is incredibly
taught, once properly shrunk. The skin of a drum comes to mind.

You can shrink the fabric too much and actually crush or bend the
framework beneath it, the fabric has that kind of strength.

Corky Scott





Corky, the polyester fabrics have long chain molecules that 'curl up'
when you heat them. This makes the actual threads shorter, so that
after the actual fabric is shrunk to size.

The butyrate doesn't shrink the fiberglass threads. It just grabs a
couple and pulls them closer together. "Chain is only as strong as its
weakest link" comes to mind. Until a butyrate coated covering stretches
enough to take out the slack that was there when the fabric was first
put on, it is only being held together by the butyrate.

That is the mental picture I have. I could be wrong, and I don't even
know if it is good or bad. For starters, I don't know how strong
butyrate dope is. It could be much stronger than polyester, and just
needs the fabric to give it some shape. I'm in unknown territory and
just need a compass and a map, or maybe just a practice kit to play with.

Didn't I read somewhere that butyrate dope can be found in most hardware
stores under a different name?

--
http://www.ernest.isa-geek.org/
"Ignorance is mankinds normal state,
alleviated by information and experience."
Veeduber
 




Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

vB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Forum Jump

Similar Threads
Thread Thread Starter Forum Replies Last Post
Fabric covering processes Jerry Guy Home Built 2 January 29th 04 06:49 PM
Fabric Work Doug Home Built 9 January 26th 04 03:31 AM
fabric and tube by the ocean. Ed Bryant Home Built 5 December 6th 03 07:00 PM
Soliciting Testimonials on Covering Systems Larry Smith Home Built 5 August 18th 03 09:24 AM
Glass Goose Dr Bach Home Built 1 August 3rd 03 05:51 AM


All times are GMT +1. The time now is 08:25 PM.


Powered by vBulletin® Version 3.6.4
Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.
Copyright ©2004-2025 AviationBanter.
The comments are property of their posters.