![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#25
|
|||
|
|||
![]()
The hand pump gives redundancy to the hydrolic system only in the event that
the electric power pack fails. In the event of an electrical failure, the hydrolic system itself would still be intact, but the hand pump is a one way pump, only allowing you to pump the gear down, not up. The 182RG's gear system is a closed hydrolic system, as it only operates the gear. To have a complete hydrolic system (gear) failure such as a blown hydrolic line or fitting causing the system to loose it's entire quantity of hydraulic fluid would be quite rare I would think. I'd much rather have a backup system to an electrical system malfunction than have a back up to an hydrolic system. Jim |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Aluminum vs Fiberglass landing gear - Pro's and cons. | Bart Hull | Home Built | 1 | November 24th 03 02:46 PM |
Aluminum vs Fiberglass landing gear - Pro's and cons. | Bart Hull | Home Built | 2 | November 24th 03 05:23 AM |
Aluminum vs Fiberglass landing gear - Pro's and cons. | Bart Hull | Home Built | 0 | November 24th 03 03:52 AM |
Aluminum vs Fiberglass landing gear - Pro's and cons. | Bart D. Hull | Home Built | 0 | November 22nd 03 06:24 AM |
Wanted clever PA32 engineer's thoughts - Gear extention problem on Piper Lance | [email protected] | Owning | 5 | July 22nd 03 12:35 AM |