![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#12
|
|||
|
|||
![]()
In a previous article, "Peter Duniho" said:
"Paul Tomblin" wrote in message ... [...] Actually, reading that again, it's possible that what is happening isn't that it comes on at a lower speed if you have power on, but that the propellor slipstream holds the gear up against the springs if you have power on. I don't know how the "propeller slipstream" could hold the gear up. The only "propeller slipstream" I'm aware of is the helical movement of the air around the fuselage, and compared to the other forces involved I doubt it's all that strong. The air coming off the propellor is going faster relative to you than your air speed. If it wasn't, your propellor wouldn't be producing power. It makes perfect sense to me. Being behind the propellor disk, the nose gear (and possibly the mains) is experiencing more dynamic air pressure when the engine is producing power than if you were gliding at the same speed. -- Paul Tomblin http://xcski.com/blogs/pt/ Can I LART an aol'r for attempting to subscribe to a majordomo list with their street address, or should I wait for a second offence? -- Allan Stojanovic |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Aluminum vs Fiberglass landing gear - Pro's and cons. | Bart Hull | Home Built | 1 | November 24th 03 02:46 PM |
Aluminum vs Fiberglass landing gear - Pro's and cons. | Bart Hull | Home Built | 2 | November 24th 03 05:23 AM |
Aluminum vs Fiberglass landing gear - Pro's and cons. | Bart Hull | Home Built | 0 | November 24th 03 03:52 AM |
Aluminum vs Fiberglass landing gear - Pro's and cons. | Bart D. Hull | Home Built | 0 | November 22nd 03 06:24 AM |
Wanted clever PA32 engineer's thoughts - Gear extention problem on Piper Lance | [email protected] | Owning | 5 | July 22nd 03 12:35 AM |