|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#7
June 21st 04, 04:08 PM
|
|||
|
|||
"G.R. Patterson III" wrote
mike regish wrote: I have a 1/4-20 bottom tap I'm going to run in to clean up the threads. One more thing you've probably already thought of. Most taps have a tapered tip. When used as a chaser, such a tap will not clean the bottom threads in a hole. You can take care of this by cutting and/or grinding most of the tapered section off the end of the tap. Well, let's see.... he did say that he has a "bottom" tap. Bob Moore 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Oil Leak on top of the engine -- follow up | Jay Honeck | Owning | 6 | February 13th 05 01:50 PM |
| Oil leak on top of the engine | Jay Honeck | Owning | 31 | February 12th 05 02:27 AM |
| oil leak question | Dick | Home Built | 18 | November 19th 04 03:14 PM |
| ~ DICK GRILLED FOR CIA LEAK - CAN YOU SAY PRISON?! ~ | ~ THE CHOKING CHIMP ~ | Military Aviation | 0 | June 6th 04 05:34 AM |
| oil leak fixed - breaking in new cylinders | Michael 182 | Owning | 24 | September 23rd 03 12:36 PM |
Threaded Mode