|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#14
July 13th 04, 04:42 PM
|
|||
|
|||
Would you mind sexing (you should pardon the expression) that connector again?
The sex of an RF connector is determined by the CENTER PIN, and not the shell. I think you mean BNC female to SMA male. Jim (RM) shared these priceless pearls of wisdom: -It's BNC male on one end, SMA female on the other. It fits onto the -Vertex antenna connector and allows a standard BNC cable to be connected -to the unit. $11 + s/h at pilotportal.com Jim Weir (A&P/IA, CFI, & other good alphabet soup) VP Eng RST Pres. Cyberchapter EAA Tech. Counselor http://www.rst-engr.com 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Antenna problems | Mike Rapoport | Owning | 16 | February 9th 05 06:04 PM |
| Retractable Comm Antenna | Ron Wanttaja | Home Built | 11 | September 6th 04 06:59 PM |
| Antenna ground plane and coax grounding | G. Fred McCutchen | Home Built | 2 | August 8th 04 12:27 PM |
| ELT antenna -- Pitts | Al MacDonald | Home Built | 0 | July 15th 04 03:27 PM |
| Ext antenna connection for handheld radio | Ray Andraka | Owning | 7 | March 5th 04 01:10 PM |
Threaded Mode