![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#18
|
|||
|
|||
![]()
Newps wrote:
I worked for four years at an airport where 95% of the traffic was from the University of North Dakota. Nothing but flight training. Students beat the hell out of airplanes and I don't recall any flat tires on the trainers. The flats all seem to happen to the biz jets and big twins. Interesting. Well, it happened to me once. [Yes, it was in a 172 also used for training.] But this is all beside the point (although interesting). The fact is that controllers do occasionally have to wave off an aircraft previously cleared for landing. At GFK we had probably 50 go arounds a day for any number of reasons. However disabled aircraft on the runway wasn't one of the top 10 factors. Here at BIL we have hardly any flight training anymore and I can't remember the last time I saw a go around. Although there are a few reasons for that too. That *is* interesting. It helps explain why I've experienced this more at CDW than elsewhere. I thought it because most of my landings, over the years, have been there (it's where I did my primary and instrument training). But CDW is also a "training heavy" airport. Not that this is too meaningful, but I cannot recall a single instance of a go-around being required at a controlled airport not CDW. I can recall hearing a go-around issued at CDW just this past week. - Andrew |
Thread Tools | |
Display Modes | |
|
|