![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#26
|
|||
|
|||
![]()
I've made hundredes of gear up landings...all of them intentional.
Of course they were on water in an amphibian!!!!ggg Nearly got suckered into a gear up landing with a Twin Beech. Short final behind a Cessna. Just as I was about to declare a "go around" the Cessna landed short and taxied off the runway. I was headed for the far end of a 6000' runway and was cleared to land. I had already cycled the gear UP and flaps to take-off and had added power when the tower cleared me to land. I immediately reduced power and only my usual "short final" check of gear, props, mixture saved us from getting that sinking feeling and the terrible noise that follows. I still followed through with an orderly go-around and thought about how the events could have caused a gear up landing. Simply reinforced my routine last check on short final to insure gear down and welded or three green. Ol S&B |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
"I Want To FLY!"-(Youth) My store to raise funds for flying lessons | Curtl33 | General Aviation | 7 | January 9th 04 11:35 PM |
Aluminum vs Fiberglass landing gear - Pro's and cons. | Bart Hull | Home Built | 1 | November 24th 03 02:46 PM |
Aluminum vs Fiberglass landing gear - Pro's and cons. | Bart Hull | Home Built | 2 | November 24th 03 05:23 AM |
Aluminum vs Fiberglass landing gear - Pro's and cons. | Bart Hull | Home Built | 0 | November 24th 03 03:52 AM |
Aluminum vs Fiberglass landing gear - Pro's and cons. | Bart D. Hull | Home Built | 0 | November 22nd 03 06:24 AM |