|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#5
September 30th 03, 08:05 PM
|
|||
|
|||
Tried that, with a shiny new freshly sharpened scissor type guillotine, and it
didn't cut it, this stuff has very fine fibres which just bent around the corners. even using heat-shrink sleeving to simulate a plastic coating, we got the same results, you simply could not be sure of cutting the rope. 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Plasma Reduces Jet Noise (Turbines?) | sanman | Home Built | 1 | June 27th 04 12:45 AM |
| Plasma Reduces Jet Noise (Turbines?) | sanman | Rotorcraft | 1 | June 27th 04 12:45 AM |
| Using Plasma Rope For Winch Tows | Craig Freeman | Soaring | 56 | August 24th 03 10:55 PM |
| Winching: Steel vs. Plasma | Bob Johnson | Soaring | 10 | August 12th 03 05:41 PM |
| 2nd update on Review of Plasma II Ignition System | MikeremlaP | Home Built | 8 | July 22nd 03 01:37 AM |
Threaded Mode