|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#6
September 29th 04, 10:31 PM
|
|||
|
|||
I don't think serial ports need dynamic prop balancing.
You guys sure know how to complex up a bonehead simple idea, don'cha? {;-) Jim (Ben Jackson) shared these priceless pearls of wisdom: If you could include the phase of the -crankshaft you could probably spit out enough information to do a dynamic -prop balance on a serial port.  Jim Weir (A&P/IA, CFI, & other good alphabet soup) VP Eng RST Pres. Cyberchapter EAA Tech. Counselor http://www.rst-engr.com 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Pilot log book and taxi testing | Bob Olds | Home Built | 1 | February 11th 04 03:32 PM |
| Pressure testing gone bad | Mark Hickey | Home Built | 17 | November 25th 03 02:29 AM |
| Looking for out of service main rotor blades for testing newro... | James Lloyd | Home Built | 0 | July 28th 03 10:27 PM |
| Looking for out of service main rotor blades for testing new rotor | Wright1902Glider | Home Built | 9 | July 28th 03 06:06 AM |
| Torsional Vibration Testing | B2431 | Home Built | 8 | July 25th 03 07:15 AM |
Threaded Mode