|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#9
November 2nd 03, 12:16 AM
|
|||
|
|||
In article ,
says... To take Bill's point further, if the film could not be shape changed somehow then there is no way you could get span length roll of film to fit tightly to the curves of a glider wing along its full length. The material under discussion, with brand names like Monokote and Solarfilm, can be formed around compound curves on a model airplane, which are far sharper than those on a full size glider. It's very thin, about 0.002 inches. See www.monokote.com -- !Replace DECIMAL.POINT in my e-mail address with just a . to reply directly Eric Greenwell Richland, WA (USA) 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Refinishing radio stack front panels | Roger Halstead | Home Built | 2 | September 15th 04 04:20 PM |
| Carbon Fiber - Achieving Glossy Finish w/o GelCoat | RKT | Home Built | 7 | March 8th 04 06:15 AM |
| Refinishing Your Aircraft (now in Oregon) | aerocomposites | Home Built | 0 | September 24th 03 05:29 AM |
Threaded Mode