![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#11
|
|||
|
|||
![]() "cernauta" wrote in message ... "Bill Daniels" wrote: Tape two yaw strings (which then become pitch strings) on each side of the canopy at the lowest and most forward part you can still see. The string angle difference between minimum sink and stall is large so the bright red, wiggling strings angled up steeply are a good visual stall warning. That must be true only for unflapped gliders, or it's valid only for one specific flap setting in a flapped glider. Or you have to make different coloured markings for each and every flap setting. Aldo Cernezzi You're right about flaps making a difference in the calibration. I've only tried this on two flapped gliders and one without flaps. However, It seemed to work pretty well in all cases. I actually didn't see too much difference in the string indications at different flap settings. The flap issue is partly moot since the flap settings are related to airspeed bands. Stall concerns would likely arise only with the flaps in their most positive two settings, landing or slow thermalling. The near-stall indication is very obvious. Bill Daniels |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
For Auction: Thermal Imaging Camera - One Day Left | sell2all | Rotorcraft | 0 | April 29th 04 08:29 PM |
For Auction: Thermal Imaging Camera - One Day Left | sell2all | Naval Aviation | 0 | April 29th 04 08:09 PM |
For Auction: Thermal Imaging Camera - One Day Left | sell2all | General Aviation | 0 | April 29th 04 08:09 PM |
Spin on thermal entry - how-to | Bill Daniels | Soaring | 0 | January 29th 04 05:43 PM |
Thermal to Wave contact! | C.Fleming | Soaring | 1 | January 21st 04 01:54 PM |