|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#5
December 5th 04, 04:47 AM
|
|||
|
|||
I used to repair/reinforce ABS plastic cowls on my radio controlled planes with
fiberglass cloth and PVC pipe cement. I would line the cowl on the inside with the glass, then use the dauber in the can of PVC cement to wet through the cloth. It would dry quickly and seemed to do the trick. I think it would probably work on plastic interior panels and interior plastic parts. 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Four Winds 192 Crash into the Miami Federal Reserve Building, a year ago today | Billgran | Home Built | 3 | December 6th 03 03:22 PM |
| It's that time of year again. | Capt. Doug | Home Built | 19 | September 3rd 03 10:53 PM |
Threaded Mode