|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#11
March 2nd 05, 04:06 PM
|
|||
|
|||
I'm not sure but suspect that file transfer could take longer in this case. (but maybe it will use another setting for pc connection). /Jancsika wrote: keithw wrote: Adjust the Baud rate from 19,200 to a lower setting , some units only respond at 4800 . -- keithw Thanks that did it! what are the disadvantages of the lower baud rate setting if any? Thanks Devin Bargainnier 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Colibri problem | Ian Cant | Soaring | 1 | August 19th 04 07:30 AM |
| iPaq wiring, cradles and mounts for gliders - Ideas?? | Jim Kelly | Soaring | 12 | December 4th 03 11:45 PM |
| RF interference issue again (esp. for E Drucker and Jim Weir and other RF wizards) | Snowbird | Home Built | 78 | December 3rd 03 09:10 PM |
| RF interference issue again (esp. for E Drucker and Jim Weir and other RF wizards) | Snowbird | Owning | 77 | December 3rd 03 09:10 PM |
| iPaq screen viewability | Raphael Warshaw | Soaring | 7 | July 27th 03 06:02 PM |
Threaded Mode