|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#10
January 9th 05, 07:59 PM
|
|||
|
|||
On Sun, 09 Jan 2005 13:09:44 GMT, "Blueskies"
wrote: " jls" wrote in message ... "Blueskies" wrote in message . com... " jls" wrote in message A hardware store washer will be just fine as long as the purpose and use is understood. This is the homebuilt forum, right? Nothing illegal about its use at all.... You're right, Mr. Blueskies. I stand corrected. Cad plating on a washer is unnecessary but it sure helps on the bolt and nut. Now safety is an entirely different matter.... Most if not all washers I see in the hardware stores are plated, if not Cad then nickel. I don't recall seeing any plain ones lately... The VAST majority are bright zinc plated. 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Plastic fender? | Steve Thomas | Home Built | 0 | August 28th 03 04:36 PM |
Threaded Mode