![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#15
|
|||
|
|||
![]()
Jim Burns wrote:
Although he sounded rude it was obvious he wasn't having a good day and at the very least had his hands full, I'm just curious about what standard procedures are for tower controllers maintaining visual contact with planes once they are actually in the traffic pattern. Standard procedure is to know where everyone is to the extent necessary to ensure that separation on the runway is provided. It is actually acceptable to clear an aircraft to land when not in sight, provided the traffic situation is such that loss of separation on the runway will not occur. In a situation where there are lots of planes in the pattern, the normal procedure is to use visual sequencing and that does mean maintaining visual contact - but this is not always possible. Bright sun and obstacles around the tower can interfere with this. This does not relieve the controller of his responsibility for correct sequencing and ensuring separation on the runway. I believe it was the creator of Dilbert who pointed out that aviation was an industry that had made no progress in decades, and that he believed flight control RADAR still involved having interns on towers with binoculars screaming "Turn right, turn right." Spookily accurate for someone without aviation knowledge. My point is basically that both pilot and controller made mistakes, but the system is such that mistakes like this are guaranteed to happen. I have also noticed that when pilots screw up in a situation where the controller is ahead of the game and not screwing up, there is very little chewing out on the radio. The pilot is, at worst, told to call the tower - calmly and professionally. Every time a controller is chewing out someone on the frequency, he is screwing up - and usually it's not his first screwup either. He's mad because he knows he didn't do a good job with the situation, and he's taking it out on the pilot. Basically, it's unprofessional. Michael |
Thread Tools | |
Display Modes | |
|
|