|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
March 27th 05, 02:35 AM
|
|||
|
|||
IO520 Hot start
Hi there, I just got my Cessna 340. My right engine is very difficult
to hot start. I have to crank several times. Have done the flooded start procedure which does not work, the only thing that seems to work is to do a normal start, bring up the throttle halfway and if the engine catches a little bit quickly lean out the mixture. But it is a crapshoot and takes too much effort. Any good tips and experiences? 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Turbine air start -- too cold? | Juan Jimenez | Home Built | 97 | March 14th 05 06:51 PM |
| Turbine air start -- too cold? | Juan Jimenez | General Aviation | 54 | February 2nd 05 04:14 AM |
| USAF = US Amphetamine Fools | RT | Military Aviation | 104 | September 25th 03 03:17 PM |
| Start Anywhere Cylinder (SSA rules proposal) | Mark Navarre | Soaring | 15 | September 25th 03 01:13 PM |
| Best Software and Hardware for Turn Area Task? | Snead1 | Soaring | 29 | August 13th 03 04:12 PM |
Threaded Mode