|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
May 16th 05, 01:17 AM
|
|||
|
|||
Rings per inch for spruce?
I've been offered some spruce for spars that's pretty much perfect in every
way except there's 21 rings per inch instead of the recommended 12-15. Good stuff or no? I don't really see the problem with finer grain spruce and in fact, can't even remember where iread it's advisable to use 12=15 rings per inch. 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| spinner paint scheme | Dick | Home Built | 3 | January 27th 05 09:58 PM |
| striped spinner | Pianome | Home Built | 1 | July 4th 04 09:56 PM |
| Compression loss on cylinder when rings line up Truth of fiction? | test it | Home Built | 10 | May 11th 04 08:11 PM |
| NEED: Source for 2 pcs Aluminium Plate 1 Inch x 4 inch 5 foot length | Spar | General Aviation | 4 | March 11th 04 11:31 PM |
| Winch rope 1/4 inch poly | Robert Curry | Soaring | 22 | January 18th 04 01:10 AM |
Threaded Mode