|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#7
May 17th 05, 12:56 AM
|
|||
|
|||
"Jay Masino" wrote in message ... Jonathan Goodish wrote: I had a local mechanic finish mine up, and the rivet heads are a little better but not much--they're pretty much smashed. So that's the way they're supposed to be, I guess. The most important things are that the pads are being held tight, and that you didn't smash the rivets so much that the pads crack. When you say smash do you mean hammer? Brake rivets should be squeezed not hammered. Ric -- __!__ Jay and Teresa Masino ___(_)___ http://www2.ari.net/jmasino ! ! ! http://www.oceancityairport.com http://www.oc-adolfos.com 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Transient alternator problem | John Clonts | Owning | 6 | July 11th 04 06:01 PM |
| Captain sim Mig-21 brake chute | Lee Hutchinson | Simulators | 7 | June 1st 04 10:51 AM |
| Real World Problem in FS9 | The Real Cali Kid | Simulators | 12 | December 6th 03 11:15 AM |
| RF interference issue again (esp. for E Drucker and Jim Weir and other RF wizards) | Snowbird | Home Built | 78 | December 3rd 03 09:10 PM |
| Brake line design question | Charlie Smith | Home Built | 0 | July 2nd 03 12:31 PM |
Threaded Mode